| |
Professional Results Easily
Flawless, seamless rings are formed easily on this revolutionary 4 piece Ring Maker tool. The smooth clear acrylic surface was designed to release the formed rings easily without distortion.
The full instruction manual can be viewed by clicking on "View Manual". Size 25 - 5 mm band width mold creates finished rings (post-fire) U.S. size 7-3/4 to 9.
NOTE: Ringmakers are labeled with Japanese sizes, see conversion chart below. The chart is based on using PMC3 and firing in an electric kiln at 1652 degrees F for 10 minutes.
Creating rings is simple:
1.Place a rolled ball of clay on the "joint" insert of the ring maker and fit top of mold into position. (image 1)
2.Use your fingers to push clay into the groove between outside shells of mold while holding pieces together firmly. (image 2)
3.Insert the center cylinder into mold and slowly push into place without releasing pressure on mold surfaces. (image 3)
4.Remove center cylinder and top of mold to reveal your formed ring. (image 4) Allow to dry partially before removing ring from mold. File, engrave, carve or add details to the surface of the ring. Fire according to instructions to enjoy your professional quality fine silver ring.
|
