| Kwik-clean Flux Cleaner - 16 Oz Description |
| |
Kwik-Clean flux remover doesn't need mixing or diluting. Just spray on Kwik-Clean when you're done soldering, then use paper towel to clean project thoroughly.
To use with patina: Use a paper towel to apply the patina. Mixing the Kwik-Clean with Patina gives added cleaning of the flux and a finer tone on the patina. After Patina is applied, clean again with Kwik-Clean. Polish as you normally would. This item cannot be shipped air.
|
|
Average Product Rating : 
Number of Reviews : 5
Best I've used!
Pros : This is so easy to use and does the job on small or large pieces.
Cons : Wish it came in gallons.
So easy!
Pros : I wish I had had this when I finished my 21x35 window panel. It is so simple to use and gets the fl... Read More
Cons : I haven't found any.
No Smell!
Pros : Very easy to use. No smell and I'm sensitive to odors. Cleaned quite well a large piece I was not ... Read More
Cons : No cons yet.
Other Thoughts : Wish I knew about it before I had to wash a five foot transom window last month!
|
