get started : bullseye hot

Get Started

Getting started has never been easier. Select a category from the pull down or search for more information. This list is pulled from our Blog, Video, and Tips areas. Looking for products? Check out our Start-Up Kits.

Bullseye Reactive Glass Presentation

Bullseye Reactive Glass Presentation Amy Ferber from Bullseye Glass visited Delphi last week, and the Reactions were fantastic. She was here to give a free presentation about using Bullseye Reactive Glass. The two hour interactive presentation included a video, and a chance to look at samples of reactions that were created using a variety of techniques and different materials and what class would be complete without a pop quiz? Attendees were asked to review the samples and identify what was used to make them. Everyone had a fantastic time. After the presentations I was able to sit down with Amy for a few minutes and talk. Here are a few of the questions I managed to sneak into her whirlwind vist Q What is the COE of Bullseye? A Although many people like to categorize glass neatly by a COE number, compatibility is actually more complex than that. Bullseye kiln glass is around

Is It Safe to Use Fused Glass for Dinnerware?

Is It Safe to Use Fused Glass for Dinnerware? The official answer from the glass manufacturers is, All tested compatible glasses have been tested by the FDA for food bearing surfaces and were determined to be suitable.However, if you add other processes or compounds to the items, for example paint, stains, decals, glazes, etc. it is important to check that these items are also approved for food bearing surfaces. In addition it is of the utmost importance that dinnerware items be properly annealed, especially if youre going to place hot food on them - the thermal shock could cause a break in poorly annealed items. This Randys ProTip brought to you from the book Introduction to Glass Fusing by Petra Kaiser. VisitWardell Publications. Also, at Delphi we take food safety and dinnerware very seriously. We always recommend that certain glasses are capped with clear. These are usually irids, dichro and glass with texture, since these can also trap

How to Make Your Own Blown Glass Ornaments

How to Make Your Own Blown Glass Ornaments GLASKOLBEN cylinders are pre-blown clear glass cylinders with blow pipe ends, used for blowing glass balls. Glaskolben cylinders are used throughout Europe for making Christmas tree ornaments. Glaskolben is a German word that translates to glass bulb. WATCHAVIDEOONBLOWINGGLASKOLBENORNAMENTS. SUPPLIES/EQUIPMENT Torch head for Mapp Gas use Gas/oxygen torch Glaskolben™ cylinder 90 COE frits and powders for decoration Ornament cap and loop set (available in gold or silver) COMPATIBILITY Glaskolben is compatible with Uroboros and Bullseye 90 COE glass frit and powders. Do not use any other COE as it may cause stress or fracture. HOWTOBLOWANORNAMENT 1. Light the torch and adjust the flame - a broader flame is better. Select a Sealed End Cylinder Glaskolben™ and introduce it into the back of the flame away from the torch. Rotate it as it is brought into the hotter area of the flame. Continue to rotate until the cylinder is glowing

Donna Sarafis: Basics of Fusing Part 1

Donna Sarafis: Basics of Fusing Part 1 Part 1 of a 2 part blog on the basics of glass fusing. In this weeks article Donna will tell us how to set up your work area and gives suggestions on finding the perfect kiln. Often potential fusers ask about the cost of getting started in glass. I found that it isnt as expensive as one might think because the list of necessities for the beginner is not too long. So what would the list look like for someone who had NO experience at all? Well, this is what I began with, and I think you might find these ideas helpful. Space to Work- A place to cut glass can be fairly small. The most important detail is a floor surface such as concrete that will be easy to clean. I tried commercial tile in my first studio, and the shards were soon embedded under the work area. Obviously,