artist gallery : alberth13

AlbertH13's Profile


Recent Activity
Tree Of Life Texture Mold

Tree Of Life Texture Mold

Item# 80884
1 of 2 found the following review helpful:
Nice Presentation, January 2, 2015 4 stars
Pros
The mold is easy to work with and provides a nice finished product with very little work.. A full fuse and a slump is all that is needed
Cons
The mold size is not a true 12x12, it is actually 11 3/4 x 11 3/4. You will need to cut a 1/4 inch off each side of a 12 x 12 piece of glass. It is sometimes difficult to cut off such a slender piece. It would be nice if you did not have to do this and the mold was a true 12 x 12. If you do not do this, your mold is subject to cracking as the glass cools because it has wrapped over the edges of the mold. Knowing this beforehand can prevent this from happening.
KraftyBlok 7-1/2 Mosaic Glass Block

KraftyBlok 7-1/2" Mosaic Glass Block

Item# 426109
Excellent...but, January 31, 2009 4 stars
Pros
The blocks are beautiful, particularly with the embedded design. I put a set of Christmas lights inside (all white) my block and it is just beautiful. This was so simple, so I can't imagine what I could create with some thought and effort. The block is a good starting point!
Cons
The only down side is the label by Kraftyblok is on both sides. It is impossible to peel off! I had to soak the block in water then scrape it off. Even then it left the residue of the glue which I had to remove with mineral spirits. This has nothing to do with the overall quality of the product but it is an annoyance. Kraftyblok should help their consumers a bit with a friendlier labeling system
EZ Fuse Software

EZ Fuse Software

Item# 7960
EZ Fuse Software, January 7, 2009 1 stars
Pros
None
Cons
I wish I had read the reviews first. No directions so installation was confusing. It kept asking for the serial number on the back of the case. There is not serial number, so registration and set up was confusing. I tried to call the support number and was told that it was no longer working. I think I finally have it installed and registered but there's not a whole lot to it so I don't know if it is correct or not. Seems like it only allows sizes for square items. It should include round items for fusing too. All in all, I'm very disappointed in this item for the amount of money it costs. I realize this is not the fault of Delphi. When looking for the serial number on the back of the case, it looks like the packaging is simply zeroxed, not printed. It's a bit fuzzy. That's not comforting either.
AlbertH13
Profile
AlbertH13's info
joined:Aug 06, 2006
location:Washington, DC US
display name:AlbertH13