HI Jennifer, I am going to increase the time of the middle 40 minutes & leave everything else the same. IF this doesn't work I will give Delphi a call, wish me luck !

Hello, I have done stained glass for maybe 10 years, just small things mostly for the enjoyment of making things for myself or as gifts. I recently purchased a used a Jen-Ken Kiln Bead Annealer with a 4 " flip door and with a AF3P ore-programmed "One Smart Controller". After several attempts I have ALMOST got the fused barrettes right, EXCEPT for they all have many "points" of sharp glass around the edges after fusing. I have tried gently grinding them off then doing a fire polish. It did work, but would like to know a way to NOT have the "points" on them to begin with. I asked on a Yahoo fusing group I belong to, and the below #'s were suggested to me. 500 to 1100; hold 30 500 to 1460; hold 20 <<<<< this segment would adjust up or down in time/temp depending upon results AFAP to 950; hold 30 I tired it, the glass looked like it barely got fused at all. SO could someone there suggest something different. I don't want to give up ;-)