Read Comments

I am working on a 22" hanging head dragonfly lamp on an Odyssey form.  I am ready to begin soldering on the lamp. However, I am not confortable about positioning the wings on the form to solder.  Also, I understand I have to solder the lamp in two sections.  Just where along the "equator" do I make this "break"?  Do the heads attach to the bottom with the wings or the top?  Do both wings attach to the bottom or do I divide them?  Any help will be appreciated.  (This IS my first Tiffany lamp. Sure wish I had known about your recommendation of starting smaller and simplier.  However, I have been doing glass for about 12 years. ) Thank you for any help.

The rebar is 1/8 inch thick and 5/16 inch wide. The length is 6 ft and it is made of zinc. You can purchase them from Delphi. Normally you will attach to the backside of the panel horizontally.

what sizes of reinforcing bar or rod should be used?  What are these rods and bars made of?  Where can we purchase them?  Do you reinforce horizontally or vertically?