Product Reviews
Pros
I love this system!!! It makes cutting straight lines so easy. I recommend this to everyone.
Cons
Just remember to order the cutter, it does not come with the main system. Not really a con, just a reminder.
Other Thoughts
Pros
awesome color and textures are very pretty. They made beautiful pendants after adding a top glass
Cons
the colors and texture seemed to fade if i added a back colored glass, so I just used a top clear glass
Other Thoughts
Will be ordering again soon
Pros
great for straight cuts ant for cutting strips
Cons
nothing except that it takes up space when set up
Other Thoughts
it is great
Pros
I can't believe how many times I could re-use this paper. I was making coasters and I cut the paper a little bigger than each individual coaster. So far I have been able to make four sets of coasters using the same pieces of paper over and over.
Cons
Not exactly sure if this is a con but make sure that you let your project cool to under 150 degrees before removing it from the kiln. I tried taking a project out when it was at about 180 degrees and the paper stuck to the back so I was not able to re-use it. But when I had the patience to wait until it was under 150 degrees, the project just lifted off the paper.
Other Thoughts
Lots of money to be saved with this paper I think.
Pros
Works great! Have had 100% success with each fireing....highly recommend
Cons
Other Thoughts
Pros
This is a grate color for beach sand
Cons
None
Other Thoughts
Pros
I like using these for scrap. I get all kinds of different effects combining dichro scrap and frit. I get a lot of compliments on them.
Cons
As with any mold, you have really coat these well with primer. I often use a small badger spray gun to spray the primer solution or just use a Hake brush. The first time I use any mold, I put at least 4 to 5 coats (dry between each) then put in the kiln for 20-30 minutes to ensure it is completely dry before using. No sense taking chances. I also give at least one coat between firings even though it isn't always necessary. Even with all that primer, if the mold is full of glass (I sometimes fire multiple times adding glass each time to make a thick pendant) the nature of the glass will make the pendant seem to "stick" to the sides. A few very light taps will loosen the glass and it will pop right out.
Other Thoughts
I don't use the small ones for earrings... I actually use them as small necklace pendants.
Pros
not only are the stringers an "confetti" pieces pretty, but the glass that contains them is crystal clear and beautiful. I will buy again.
Cons
none
Other Thoughts
Pros
This mold has the most beautiful pattern.
Cons
Too big for the smaller table top kilns.
Other Thoughts
I did not pay attention to the size and it is too big for my kiln. would like this pattern in a smaller square tile mold. ;)