Read Comments

Hi, I recently bought the mold to make the pendants and earring sets. I used a kiln wash on the mold, coating 5 times. I fused the glass and now cannot get the glass out of the mold. Any suggestions?

@peggiejane hi peg my email is [email protected]

@zoomer Dear Zoomer ? I enjoy reading your blogs and I am interested in the plans you have for the cutting light box table ? I'm not sure what to call it exactly , you said you could send me the plans on how to make the cutting table, I am setting up a shop and this is one thing that would be helpful to me , at this stage in setting things up. I'm intrigued by your experience and I will continue to keep reading and learning all the tips and tricks I can from you .` I'm not sure if you get my email added when i send this ,I'm pretty sure i;m not supposed to add it to this comment. so if I don't hear back I'll try you again. as, I'm learning at all this ! anyway ,yes please send me the plans for the roll around light box ,for cutting glass .Thank you so much ,Peggiejane

You will want to start with a boron nitride mold release we recommend MR-97 item number 93701. You can find a video on our website with application instructions. You will then fill your mold with frit (and the amount is based entirely on the expected thickness of the finished piece.) Just be careful not to overfill as that can create problems when you go to release your project from the mold. You can do some amazing work with these molds but it will likely take some trial and error before you get consistent results. Good luck and have fun!

I purchased a celtic cross mold from delphi. It did not come with fill weight. I'm new to hot glass and am the sure how to proceed. Thanks for any help anyone can give.

i have a celtic cross mold. i'm not sure how to use it. help please. i'm assuming i use colour deverre but not sure how much frit to use.

Hi, I am working on a panel using the copper foil method of construction. The panel is 21" tall and 30" wide. After reading thru some of the responses here, I am a little confused. Should I be reinforcing my panel horizontally or vertically every 18"?

Does anyone have an answer for this? I have destroyed 3 molds, have glass stuck in two more. I followed all the directions using the recommended primer.

i very seldom make my windows using lead came i work in copper foil so i reinforce with 12 gauge copper wire soldered right into the solder lines.it becomes invisible i also use this technique on my lamp shades

Can anyone help me with patinas? I love the look of antique gold patinas, but every time I try to apply it I wind up with a mess which I have to cover up with black patina. No matter how thoroughly I clean and wirebrush my lead lines, when I apply the antique gold I initially get that beautiful color I'm looking for, but then it suddenly turns to a bright copper color and only a few spots keep the antique gold color. I can't figure out what I'm doing wrong. My black patinas are generally pretty flawless.