Pros
Perfect size for holding earrings

Cons
Pricey unless with a BOGO

Other Thoughts
They might release from the earring but I have found if I rough them up with my dremel, you can't pry them off if you wanted to. I use E6000 & it works great.

Pros
beautiful mix of dichroic stix, They fire well. All are different.

Cons
none

Other Thoughts

Pros
Very handy and easy to work with

Cons
none

Other Thoughts

Pros
This stuff is GREAT! I can cut a small piece just big enough for my project. Glass bottom is always smooth after firing. I use a shop vac to suck up the remains after removing my work. I always buy the 24"x24" sheets. GREAT STUFF!!

Cons
Cons? Hmmmmm, running out of paper and waiting for more to arrive? There are no cons..

Other Thoughts
I wish it were cheaper and I could buy by the roll.

Pros
Good Selections, worth the money. all individually packed in plastic pockets and sealed.

Cons
One of the pieces I received was less than the size described because it was obviously from the edge of the sheet as the size was curved off. got about half inch less in size.

Other Thoughts
Wish there was a slightly better Quality Control so that customers get the total area they paid for.

Pros
loved working with this glass i had the score it on both sides to break it

Cons
i had to score it on both sides

Other Thoughts

Pros
loved working with this glass i had the score it on both sides to break it

Cons
i had to score it on both sides

Other Thoughts

Pros
It is easy to use and with 16oz you don't have to worry about running out in the middle of a project.

Cons
Can be awkward to handle in tight places.

Other Thoughts

Pros
Lots of color, and creates a different look than just fusing squares of different textures and patterns of dichro sheet together. The pieces I make with this are usually big sellers.

Cons
Really works best if you fuse this using two layers of black as a base then a clear coat on top, so it does take a bit more glass than the typical two layer fuse and one extra full fuse cycle in the kiln. I just charge more for the pieces.

Other Thoughts
I work with slabs and then use a ring saw to cut pieces up after and then fire polish them. The way I have found that this product works best for me is to place it on top of two sheets (4x4's for me)of either black or cobalt blue glass (the blue is my favorite), full fuse, then cover with a sheet of clear and full fuse again. This creates the least amount of bubbles and covers up the rough edges that can be left behind if you don't clear cap it. I then cut the slab up with a ring saw and fire polish to finish. The pieces are beautiful!